SGA, SHA - TRITON

Hybrid cabinets SGA, SHA

Cooling

The cabinet interior is cooled by ventilation perforations in the cabinet door.

Bonding

Made according to the relevant standards.

Door lock

Double bit and other lock options ensure that the cabinet is securely locked.

Vertical mounting

The top half of the cabinet is fitted with sliding mounting brackets for 19“ patch panels or a fuse trough.

Horizontal mounting

Brackets are attached to the lower part of the cabinet for 19“ equipment.

Break-out panels

The top and bottom of the cabinet are fitted with wiring inputs covered with break-out panels.

Hybrid wall cabinet with IP20/ IK07 protection.
The cabinet is hung directly on the wall (SHA); another option is the SGA, installed in a prepared space under the plaster.
The cabinets include two pairs of step-adjustable brackets with 19“ spacing.
Cabinet construction:
– Welded frame from 1 mm thick sheet steel.
– All steel door of 1 mm thickness with foam seals around the edge.
– The cabinet door is connected to the frame by an earthing cable, which must be properly secured and inserted into the connectors for the entire duration of the cabinet’s use.
Break-out caps in the upper and lower parts of the cabinet.
Maximum permissible load – cabinets: 30 kg; door: 4 kg.
Min. thickness of the surface finish is 65 μm.
These cabinets are intended for the use of data and telecommunication equipment and their distribution and power supply systems.
The frame of the cabinet and all removable parts (side and rear covers, doors…) are bonded with patch cables that have to be properly fixed and inserted into connectors throughout the period of use of the cabinet.
There is one M8 screw placed on the bottom part of the cabinet to connect the bonding.

Operation conditions

Operation environment

the office
the cabinet is not intended for outdoor installations and for installations in environment that can negatively influence the functionality of the cabinet and the mounted devices (e.g. environment with danger of explosion or humid and wet surroundings).

Must be protected against

Improper handling is especially

overloading (exceeding the maximum recommended load),
device installation that can negatively influence the operation and function of the cabinet or the installed equipment,
change of the construction or design of the cabinet.

Installation of the cabinet

To ensure the maximum recommended load, it is necessary to distribute the load evenly.
Place the cabinet on a flat floor and adjust any differences using levelling feet.
To avoid dust penetration in case the cables lead through some of the cable openings, it is possible to seal it using a blanking panel with a brush and equip it with a hem edge (both are included in the supply).

Environmental protection